Description
Same kit can be had with or without handle cut-outs. Add notes if you do not need cuts
Material – Reinforced FRP, with an added layer of multi-axial fiberglass cloth. This has improved the structural rigidity of the fenders. Letting us make them very lightweight yet designed to withstand contacts with your rims edge, stones, blown tire etc.
+75mm front width per side
+75mm rear width per side
Meant to fit in drift angle kits such as WISEFAB, SLR, and others with recommended rim width/offset
Designed to work with 0(zero) camber setup in the rear.
Meaty setup welcome like 245/40/17, and slightly stretched 18’s
Designed to work with OEM handle. Just take off your handle relocate it to the overfenders panel and secure it with OEM bolts. Install simple pull rod via zip ties) to connect with the door lock lever.
Perfect fit to your 4 door E36.
A rear arch line will be reformed and lifted by approximately 15mm so you’ll be able to properly level your E36. No more exposed rear axle and muffler.
*Offset your front bumper forward and to the sides by sliding them out of the side bracket and letting it rest on them secured with a screw underneath bumper molding trim.
*Modifications to a car shell needed. Like cutting, trimming and welding.
*Prior to painting it is suggested to pre-heat overfenders, contact us for more details
*For cars with M-moldings about 2mm sanding of rear door overfenders and front overfenders lower sides is necessary in order to fit “fat” moldings
